1.地面與裙角用堅固、防滲的材料建造；有泄漏液體收集裝置、氣體導出口和安全照明設施。

1. The ground and skirt corners are constructed with sturdy and impermeable materials; There are leakage liquid collection devices, gas outlets, and safety lighting facilities.

2.采用高密度聚乙烯膜作為人工合成材料襯層的貯存場應提交人工防滲襯層完整性檢測報告。連同施工報告、全套竣工圖、施工質量保證書等其他檢測報告作為竣工環境保護驗收的依據。

2. The storage yard using high-density polyethylene film as the artificial synthetic material lining layer should submit an integrity testing report for the artificial anti-seepage lining layer. Along with other inspection reports such as construction reports, complete completion drawings, and construction quality assurance certificates, they serve as the basis for environmental protection acceptance upon completion.

3.危險廢物暫存間地面上方鋪設2mm厚HDPE高密度聚乙烯防滲土工膜,并上返裙角50cm,在其上方鋪20cm強度等級為C30混凝土,最后刷2mm環氧地坪漆,裙角抹1cm厚砂漿,門口設置20cm圍堰。設置導流槽、廢液池,并在上方鋪設鋼格柵。

3. A 2mm thick HDPE high-density polyethylene anti-seepage geotextile film is laid above the ground of the hazardous waste storage room, and 50cm of the skirt corner is returned. A 20cm strength grade C30 concrete is laid above it, and finally a 2mm epoxy floor paint is applied. A 1cm thick mortar is applied to the skirt corner, and a 20cm cofferdam is set at the entrance. Set up diversion channels and waste liquid tanks, and lay steel grilles above them.

4.貯存場所符合《危險廢物貯存污染控制標準》的有關要求（貯存場所地面須作硬化及防滲處理，場所應圍堰或圍墻）。

4. The storage site meets the relevant requirements of the Pollution Control Standards for Hazardous Waste Storage (the ground of the storage site must be hardened and treated with anti-seepage, and the site should be surrounded by a cofferdam or wall).

5.危險廢物貯存場所具體圖形標志及標準用語參考《環境保護圖形標志—固體廢物貯存（處置）場》（GB 15562.2-1995 ）、《危險廢物貯存污染控制標準》GB18597-2001）及其附錄等。

5. The specific graphic signs and standard terminology for hazardous waste storage sites refer to the "Environmental Protection Graphic Signs - Solid Waste Storage (Disposal) Sites" (GB 15562.2-1995), "Pollution Control Standards for Hazardous Waste Storage" GB18597-2001) and its appendices.

6.貯存場所地面須作硬化處理，以混凝土、磚、或經過防止腐化處理的鋼材料進行建設,地面涂至少2mm高的環氧樹脂，以防止滲漏和腐蝕（滲透系數≤10-10厘米/秒）。

6. The ground of the storage area must be hardened and constructed with concrete, bricks, or steel materials that have undergone anti-corrosion treatment. The ground should be coated with at least 2mm high epoxy resin to prevent leakage and corrosion (permeability coefficient ≤ 10-10 centimeters/second).

7.存放液體性危險廢物的貯存場所必須設計導流槽和收集井。場所應有雨棚、圍堰或圍墻，場所需要密閉且有通風口。

7. The storage site for storing liquid hazardous waste must be designed with diversion channels and collection wells. The place should have a canopy, cofferdam, or wall, and the place should be sealed with ventilation openings.

8.箱體墻壁采用不低于1.2mm鋼板雙層。

8. The box walls are made of double-layer steel plates with a thickness of no less than 1.2mm.

9.箱體墻壁采用不低于50mm防火保溫。

9. The walls of the box body shall be equipped with fire insulation of no less than 50mm.

10.符合對于集裝箱消防及安全、抗震、環保防腐等要求。

10. Meet the requirements for container fire safety, seismic resistance, environmental protection, and corrosion prevention.

本文由 危廢暫存間友情奉獻.更多有關的知識請點擊:http://www.azsolar.cc我們將用真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

This article is dedicated to the temporary storage of hazardous waste. For more information, please click: http://www.azsolar.cc We will provide you with comprehensive service with a sincere attitude. We will gradually contribute more relevant knowledge to everyone. Stay tuned